Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Alpine, CA
Gate installation in Alpine is different from work closer to the coast because most properties sit on multi-acre, sloped backcountry lots with wide driveway entrances and long, often unpaved approaches. The dominant job here is a heavy, long-span automatic gate built to hold up under Santa Ana wind loads, foothill heat, and soil settlement on graded entries. Riverside Gate Company has served Alpine since 2011, and we stock and service nine major gate automation brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Call (855) 942-4867 for a free estimate on your Alpine property.
Why Alpine Homes Are Different
Alpine sits in the East County foothills at roughly 1,500 to 2,000 feet, and the elevation changes how automatic gates fail and what they need to last. Summers run hotter than coastal San Diego, which cooks control boards mounted in direct sun and stretches or stiffens drive belts on older operators. Winters bring occasional frost at the higher parcels, and fall brings dry Santa Ana wind that loads wide gate leaves laterally, stressing hinges, posts, and motor gears. Dust and fine debris from unpaved driveways collect in wheels, tracks, and hinge bearings, which turns a minor friction problem into a burned-out motor faster than most owners expect.
The housing stock in 91901 and 91903 is mostly ranch-style and custom rural homes on multi-acre parcels, plus manufactured homes and compounds with detached shops and barns. These properties almost always call for wide driveway gates and sometimes livestock or secondary security gates, not short suburban pedestrian gates. The recurring failure we see is sagging and dragging leaves from post and footing settlement on graded entries. Re-setting a post or re-leveling a track before anything else is standard procedure here, not an upsell.
Styles & brands we work with
Our Main Alpine Services
Most Alpine customers reach us for one of two reasons: a gate that has stopped working completely or an electric system that opens and closes unpredictably. Both are specialties here.
Gate Repair in Alpine
Gate repair in Alpine usually starts with a wide driveway leaf that sags, drags, or has pulled free of its post because the footing shifted on sloped or unpaved ground. We re-set posts, re-level tracks, rework hinges, and replace worn hardware, then address the motor if the mechanical stress has damaged it. Because lots are large and gates are heavy, we bring equipment sized for long leaves and compound entries rather than a standard suburban gate kit. Gate Repair in Alpine is handled by the same gate-exclusive technicians, never a generalist crew.
Electric Gate Repair in Alpine
Electric gate repair in Alpine covers the automation side: motors that trip breakers, control boards that fail after heat or power-surge events, sensors blocked by dust, and keypad or intercom systems that stop responding. We work on nine brands including LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, so we repair the system you already have rather than pushing a replacement. Electric Gate Repair in Alpine is a defined specialty of ours, not an afterthought.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Alpine
Gate installation in Alpine means building for a rural backcountry lot: long, heavy leaves on wide openings, sloped ground that settles, and wind that pushes gates hard from the side. The specific problem we solve here is a gate that survives the first grading season and the first Santa Ana event without sagging, dragging, or burning a motor because the posts, track, and operator were sized for the actual site. We sell and install everything from entry-level residential systems like Mighty Mule and Ghost Controls to professional-grade commercial operators from FAAC, BFT, DoorKing, and Viking. Every installation is quoted and agreed before work starts, and we pull the permits Alpine requires where they apply. See our full Gate Installation page for the complete scope.
Automatic Gate Installation
Signs you need it
You have a wide driveway entry that you want to open without leaving the vehicle, or an existing manual gate has become too heavy to swing comfortably.
What it costs in Alpine
Automatic gate installation in Alpine typically runs $1,100 – $7,600 for the complete operator, hardware, and access equipment, depending on the drive system and gate weight.
How we do it
We measure the opening and slope, set posts to handle the leaf weight and local wind, mount the operator, run power to the control board, and program remotes, keypad, and safety edges before testing full cycles.
Gate Installation Services
Signs you need it
You are adding a new driveway, barn, or perimeter entry and need a gate hung and fitted that will not sag on sloped or unpaved ground.
What it costs in Alpine
Full gate installation services in Alpine typically fall between $1,100 and $7,600, with the final number set by gate width, leaf material, and whether automation is part of the job.
How we do it
We set posts at the proper depth for Alpine’s graded soils, hang and balance the leaf, install hinges and latches sized for the load, and connect automation or access control where specified.
Electric Gate Installation
Signs you need it
You have a gate, or you are installing one, and you want a wired motor, control board, sensors, and entry system that handles daily use reliably.
What it costs in Alpine
Electric gate installation in Alpine ranges from $1,100 to $7,600, driven by operator type, gate weight, power-run distance, and whether safety edges and battery backup are included.
How we do it
We match the operator to the actual leaf weight and duty cycle, run the electrical to code, install the control board and safety edge system, and program remotes plus any keypad or intercom.
Driveway Gate Installation
Signs you need it
Your Alpine driveway entrance is wide, sloped, or irregular, and a standard pre-hung gate will not clear the grade or hold up to wind and settlement.
What it costs in Alpine
Driveway gate installation in Alpine commonly runs $1,100 – $7,600, with the upper end covering long-span leaves, heavy steel, and operators rated for frequent use.
How we do it
We build for the actual site: posts set below the settlement zone, hinges and leaves matched to the opening and slope, and an operator sized to move the gate without stalling in wind.
Sliding Gate Installation
Signs you need it
Your entry slopes upward directly behind the gate, so a swing leaf would hit grade, or the driveway is too tight for a gate that arcs into the roadway.
What it costs in Alpine
Sliding gate installation in Alpine typically falls between $1,100 and $7,600, depending on gate length, track type, and the motor required to move the total weight.
How we do it
We lay the track on compacted, re-graded ground to prevent future settling, mount the operator and rack, set the safety eyes, and test the full travel repeatedly before sign-off.
What Gate Installation Costs in Alpine
| Item | Typical range in Alpine |
|---|---|
| Gate operator and controls | $900 – $5,600 |
| Driveway gate and hardware | $1,100 – $7,600 |
| Full automatic gate installation with access system | $1,100 – $7,600 |
Do I need a permit for a new driveway gate in Alpine?
Yes, in many cases. Alpine falls under San Diego County jurisdiction, and gates that affect driveway setbacks, visibility, or an existing access easement often need county approval. We handle the permit application when required and do not start until it is issued. Call (855) 942-4867 for a free evaluation.
What type of gate is best for a sloped Alpine lot?
Most sloped lots do better with a sliding gate or a swing gate with hinges and posts engineered for the grade. We assess the actual rise over the driveway length and recommend a configuration that will not drag after the first year. Estimates are free.
Brands We Service in Alpine
We work on the brand you have. That includes FAAC, BFT, Linear, and Viking on the automation side, plus the rest of our nine-brand lineup for residential and commercial systems. We stock common parts locally for these operators, which means most Alpine repairs complete in one visit. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Alpine, CA
| Service | Typical range in Alpine |
|---|---|
| Gate operator and controls | $900 – $5,600 |
| Gate motor or board repair | $280 – $1,400 |
| Driveway gate and hardware | $1,100 – $7,600 |
| Electric gate repair | $280 – $1,500 |
| Automatic gate installation | $1,100 – $7,600 |
| Full gate installation with access system | $1,100 – $7,600 |
| Sliding gate installation | $1,100 – $7,600 |
| Electric gate installation | $1,100 – $7,600 |
Prices in Alpine push toward the upper end of those ranges when a gate is wide, heavy, or mounted on a sloped entry that needs post re-setting and regrading before any motor work makes sense. You get an upfront, line-item price before we start, and the figure we quote is the figure you approve.
Neighborhoods We Serve in Alpine
We cover all of the 91901 and 91903 ZIP codes, from the custom lots off Alpine Heights Road to the ranch parcels and manufactured-home compounds closer to South Grade and Victoria. Our typical response for a gate emergency in Alpine is same day or next morning, depending on the day and how far out the driveway sits.
- Alpine Heights
- Victoria Drive area
- South Grade Road parcels
- Dehesa Road corridor
- Tavern Road area
Service Area – Cities Near Alpine
In addition to Alpine, we serve the surrounding East County communities where the same long-driveway, sloped-lot gate challenges apply. That includes Harbison Canyon, CA, Jamul, CA, Eucalyptus Hills, CA, and Lakeside, CA. Call (855) 942-4867 to confirm a pickup time for your address.
Serving Alpine, CA — Our Local Coverage Area
We’re based in the Alpine area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Alpine
In most Alpine cases we can reach you the same day or the next morning. Severe faults like a gate stuck open, a motor that will not stop, or a control board blowout after a power surge get triaged as emergencies. Call (855) 942-4867 and we will give you a direct arrival window.
Yes. For new gate installations we handle county permit applications where required. If an HOA governs your community, we supply the specifications and drawings the board typically requests before approving gate style, height, and operating system.
Check the breaker and the wall switch first, then look at the gate itself to see if a leaf is resting on the ground or a wheel has jumped the track. If power is present and the gate still will not move, leave the panel alone and call us. We walk you through a safe check and schedule the repair.
Call Riverside Gate Company at (855) 942-4867 for a free estimate on gate installation, repair, or electric gate work anywhere in Alpine, CA. The price is agreed before any work starts.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Alpine Customers Say
"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
— Bethany Meyer"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Rohan Sharma"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Shannon Fletcher