Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Fontana, CA
Gate installation in Fontana usually means replacing a 40-to-60-year-old wrought-iron original or a builder-grade aluminum gate that failed early, and the job moves faster when the company already knows what those older Fontana properties hold. Riverside Gate Company has served Fontana since 2011, so our crews expect the rusted bottom rails on Sierra Avenue homes, the sagging RV gates in 92336, and the undersized self-closing hinges on early-2000s subdivisions. We install gates that hold up to Inland Empire heat, Santa Ana winds, and irrigation overspray, and we quote every job before work starts. Call (855) 942-4867 for a free measure and a written price.
Why Fontana Homes Are Different
Most of Fontana’s housing stock was built fast for Kaiser Steel workers between the 1950s and 1970s, and those tract homes still carry their original steel and wrought-iron gates. In ZIP codes 92335 and 92336 especially, driveway gates have been swinging on the same hinges for half a century. The posts were set in concrete that has cracked and shifted, the steel has rusted where sprinklers hit it every morning, and the latch hardware is a mix of whatever a previous owner found at the hardware store. Fontana’s climate does not give these gates a break. Summer temperatures over 100°F expand the metal, Santa Ana winds force the gate against the latch and hinges, and the dry air ages bushings and rollers faster than coastal air ever would.
Newer north Fontana neighborhoods tell a different story. Builders installed aluminum gates in the early 2000s that look fine for five or six years, then the self-closing hinges wear out and the gate starts dragging. The frame is light enough that a single windy afternoon can knock the gate out of plumb. Whether we are working on a 1965 steel swing gate off Arrow Boulevard or a 2015 aluminum driveway gate in a north Fontana subdivision, the installation has to account for the same conditions: UV exposure, hard water, and ground that moves a little more every dry season.
Styles & brands we work with
Our Main Fontana Services
Fontana homeowners call Riverside Gate Company for two reasons more than any other: a gate that will not open or close properly, and an electric opener that stopped listening to the remote. Both deserve a gate specialist rather than a general repair person, because both involve mechanical alignment and electrical work together.
Gate Repair in Fontana
When a Fontana gate starts dragging, sagging, or refusing to latch, the cause is usually one of three things: rusted hinges on an older steel gate, a post that has shifted in cracked concrete, or a latch that has been hit one too many times by the wind. Our repair crews see all three every week across 92335 and 92336. We replace hinges with heavier-duty hardware, reset posts in fresh concrete where the old footing has failed, and straighten rails so the gate closes square. Full details on repair pricing and same-day service are on our Gate Repair in Fontana page.
Electric Gate Repair in Fontana
Electric gates fail in Fontana for predictable reasons: control boards that overheat in direct sun, sensors that drift out of alignment, and motors that strain against a gate that was already binding. We diagnose from the motor to the control board, and we carry parts for BFT, Linear, Viking, and Ghost Controls systems so most repairs happen in one trip. If the opener still runs but the gate will not move, the problem is often mechanical rather than electrical, and that is exactly the kind of diagnosis a generalist misses. See our Electric Gate Repair in Fontana page for symptoms, repair costs, and how quickly we can get out.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Fontana
New gate installation in Fontana is rarely a simple swap. On the older streets, the original gate is often welded to posts that were set before the street was paved, and the whole assembly has to come out before anything new goes in. On newer properties, the gate that came with the house is usually aluminum and light, but the mounting surface and the opener wiring were never built for anything heavier, so the installation has to include upgrades to the posts, hinges, and sometimes the electrical run. Riverside Gate Company handles the complete job: removal, post work, gate fabrication or ordering, operator mounting, and final adjustment for the way Fontana sun and wind will treat the gate over the next decade. We install Gate Installation jobs of every type, from a simple pedestrian gate to a full commercial slide-gate system.
Automatic Gate Installation
Signs you need it
If you are still getting out of the car to open a driveway gate by hand, or your current opener is decades old and parts are unavailable, a new automatic operator is the right call.
What it costs in Fontana
Automated gate operator installation in Fontana typically runs $1,100 to $4,200, depending on whether it is a single swing, dual swing, slide, or barrier arm.
How we do it
We check the gate’s weight and travel, mount the operator and safety edges, run or reuse the power supply, and program remotes, keypads, and vehicle sensors to work together.
Driveway Gate Installation
Signs you need it
A driveway gate that drags on the ground, leans inward toward the day’s sun, or has been welded back together twice is usually past economical repair, especially on Fontana’s older steel gates.
What it costs in Fontana
Driveway gate installation in Fontana runs $1,500 to $9,000, with steel swing gates on the lower end and full slide-gate systems on the upper end including track and automation.
How we do it
We remove the old gate, set new posts or repair existing footings, hang and square the new gate, and adjust the hinges so the gate stays level through Fontana’s summer-to-winter temperature swings.
Sliding Gate Installation
Signs you need it
If your driveway slopes upward from the street or you have a narrow setback where a swing gate cannot open fully, a slide gate saves the usable space a swing gate would eat.
What it costs in Fontana
Sliding gate installation in Fontana typically runs $2,000 to $11,000, depending on gate length, track or cantilever design, and whether an electric operator is included.
How we do it
We pour a track or set cantilever rollers, hang the gate, and connect the operator with the right safety sensors and a stop point that keeps the gate clear of the driveway edges.
What Gate Installation Costs in Fontana
| Item | Typical range in Fontana |
|---|---|
| Automatic gate operator | $1,100 – $4,200 |
| Driveway gate (steel or aluminum, manual) | $1,500 – $6,000 |
| Sliding gate with operator | $2,000 – $11,000 |
Prices move up in Fontana when the old posts have to be pulled and re-poured, when the electrical panel cannot support the new operator without a dedicated circuit, or when the gate has to be custom-sized for an odd driveway width on an older lot. Every estimate is written, quoted before work begins, and agreed to before any demolition starts.
How long does gate installation take in Fontana?
Most standard gate installations in Fontana are completed in one or two days after the gate is fabricated or delivered. Custom steel gates and slide-gate systems with new track work can take three to five days including concrete cure time. Call (855) 942-4867 and we will give you a schedule along with the written estimate.
Do I need a permit to install a gate in Fontana?
Many Fontana gate installations require no permit, but automatic gates and new electrical runs often fall under city permitting requirements, especially where the gate sits near the sidewalk or public right-of-way. We handle the permit check for you and tell you exactly what is required before any work starts. Call (855) 942-4867 and we will check your specific property.
Brands We Service in Fontana
We work on the brand you have. Our Fontana trucks carry control boards, remotes, safety edges, and common parts for BFT, Linear, Viking, and Ghost Controls, plus the full list of operators our brands page covers. If your opener is less common, we source parts same week and keep you informed on the arrival date.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Fontana, CA
| Service | Typical range in Fontana |
|---|---|
| Gate repair diagnostic | $90 – $225 |
| Gate hinge replacement (single) | $180 – $340 |
| Gate post reset in concrete | $350 – $850 |
| Automatic gate opener repair | $220 – $1,000 |
| Electric gate motor replacement | $850 – $1,700 |
| Control board replacement (electric gate) | $600 – $1,400 |
| Driveway gate installation | $1,500 – $9,000 |
| Sliding gate installation | $2,000 – $11,000 |
The two things that push Fontana repair prices up are age and neglect: a 1960s gate with seized hinges and a rusted frame takes more hours than a 2015 aluminum gate with a bad hinge, and a gate that has been scraping for three years has usually damaged the latch and post as well. Whatever the final number, it is quoted before we start, and there is no surprise line item at the end.
Neighborhoods We Serve in Fontana
We take calls across all four Fontana ZIP codes, 92334, 92335, 92336, and 92337, with most repair calls answered same-day or next morning depending on the time of day. Installations are scheduled around concrete work and gate fabrication lead times.
- Downtown Fontana and the older grid off Sierra Avenue
- North Fontana subdivisions in 92336
- Southridge and the neighborhoods near Jurupa Hills
- West Fontana along Arrow Boulevard
- Walnut Village and the blocks near Kaiser High School
Service Area – Cities Near Fontana
Riverside Gate Company covers Fontana and the surrounding Inland Empire communities. If you are just over the city line, we still take the call: Bloomington, CA, Rialto, CA, Glen Avon, CA, and Pedley, CA are all regular parts of our route, and crews are in those areas several days a week.
Serving Fontana, CA — Our Local Coverage Area
We’re based in the Fontana area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Fontana
For emergency gate repairs in Fontana, we typically arrive same-day or the next morning. Non-emergency installations are scheduled within one to two weeks depending on gate fabrication and concrete work. Call (855) 942-4867 and tell us what is failing, and we will give you a real arrival window, not a vague promise.
Some newer Fontana subdivisions do have HOA rules about gate height, material, and color, particularly in north Fontana. We have worked within those rules long enough to check the requirements before you order a gate, so the installation does not get rejected after the fact. If you have your HOA’s guidelines, we will match them exactly.
Yes. We install and repair slide gates, barrier arms, and access-controlled entry gates at Fontana apartment complexes, storage facilities, and commercial properties. Commercial operators from BFT, Viking, and Linear are brands we service regularly, and we carry the safety-edge parts those systems require to stay compliant.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fontana Customers Say
"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
— Bethany Meyer"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Rohan Sharma"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Shannon Fletcher