Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Mentone, CA
Gate installation in Mentone usually involves wide driveway and ranch-entrance systems built for long gravel approaches, horse properties, and hillside acreage, not compact suburban front yards. Riverside Gate Company has served Mentone since 2011, and we handle every part of the job from setting posts in decomposed granite soil to wiring the operator, safety loops, and keypad. If you’re planning a new gate or replacing one that’s sagged past saving, call us at (855) 942-4867 for a free on-site measure and a written price before any work starts.
Why Mentone Homes Are Different
Mentone sits at the foot of the San Bernardino Mountains, and the gate work here follows the land. Most properties in the 92359 ZIP are larger lots with long driveways, many unpaved or gravel, serving older mid-century ranch homes, manufactured homes, and small equestrian parcels with outbuildings. A gate in Mentone is typically a property-line or driveway installation, not a decorative yard gate, and many of them are decades old.
The soil is the quiet problem on nearly every job. Sandy decomposed granite drains fast but settles and shifts, so posts lean, gates drop at the latch side, and operators mounted on shifting columns lose their limit settings. Add hot inland summers, dry wind-driven grit off the pass, and occasional winter rains that swell the ground, and you get hinges that bind, rollers that grind, and motors that work harder than they should. Wind matters here too. Santa Ana and downslope gusts can shove a wide tube-steel gate hard enough to bend hardware or strip a gear if the operator wasn’t spec’d for the exposure. When we quote a gate in Mentone, we’re sizing it for wind load, driveway length, and soil conditions, not just the opening width.
Styles & brands we work with
Our Main Mentone Services
Most Mentone calls start with one of two problems: a gate that won’t open or close properly, or an automatic system that has stopped responding. Both are covered in depth on their own pages.
Gate Repair in Mentone
Mechanical gate repair in Mentone means dealing with what the environment does to heavy gates over time. Hinges and rollers packed with decomposed granite grit, posts that have settled out of plumb, weld points fatigued by years of wind gusts, and latch hardware that no longer lines up. We repair the gate where it stands when we can, and when the frame or post footings are too far gone, we’ll tell you straight and price a replacement instead. See the full breakdown on our Gate Repair in Mentone page.
Electric Gate Repair in Mentone
Automatic gate systems fail differently out here. Control boards bake in the summer heat, photo eyes drift out of alignment on shifting posts, and operators lose their travel limits as the gate sags. We carry parts for the brands most common in Mentone, including Ghost Controls, Mighty Mule, DoorKing, and Elite, so most repairs happen in one trip rather than two. Read more on the Electric Gate Repair in Mentone page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Mentone
New gate installation in Mentone has to account for what’s under the gate and what blows against it. Decomposed granite soil lets posts shift unless they’re set deep and wide, and a gate hung across a long gravel driveway catches far more wind than one tucked against a house. That’s why we measure the full site, check the grade, and spec the posts, hinges, and operator as one system before we quote anything. If you’re replacing an old chain-link or tube-steel gate on an acreage parcel, or building new access for a horse property, the full scope of what we install is detailed on our Gate Installation page. Prices are quoted and agreed in writing before any work begins. Call (855) 942-4867 for a free measure.
Automatic Gate Installation
Signs you need it
You’re opening and closing a wide driveway gate by hand several times a day, or you want controlled access without leaving the vehicle.
What it costs in Mentone
Expect to pay between $6,500 and $13,000 for a complete automatic gate installation in Mentone, including the operator, safety edges, and standard control panel.
How we do it
We set the gate and operator posts in concrete below the frost and movement line, hang the gate, then mount the operator, wire the control board, install safety photo eyes and edges, and program remotes, keypads, and vehicle sensors.
Driveway Gate Installation
Signs you need it
Your existing driveway gate no longer closes square or has been patched so many times that replacement costs less than another round of repairs in Mentone’s wind and grit.
What it costs in Mentone
A new driveway gate installation in Mentone typically runs from $2,500 to $6,500 for the gate, posts, and hardware, depending on width, material, and whether automation is included.
How we do it
We remove the old gate and posts, dig new footings sized for the soil, set the posts, hang and level the gate, then adjust the hinges and latch so it swings true and stays put through the next Santa Ana season.
What Gate Installation Costs in Mentone
| Item | Typical range in Mentone |
|---|---|
| Driveway gate and hardware (no operator) | $2,500 – $6,500 |
| Complete automatic gate system | $6,500 – $13,000 |
| Operator and access controls only (on existing gate) | $1,800 – $4,000 |
Do you handle the power run and the safety edges?
Yes. We run the low-voltage power to the operator and install the required safety edges and photo eyes. The price is quoted and agreed before any work starts.
How long does a gate installation take in Mentone?
Most residential driveway gate installations take one to two days once materials arrive. Custom gates or long ranch entrances may add a day for concrete cure time and final operator programming.
Brands We Service in Mentone
We work on the brand you have. Our Mentone trucks routinely carry parts for Ghost Controls, Mighty Mule, DoorKing, and Elite systems, which means we can often repair an operator the same day instead of ordering parts and coming back. See the full list on our brands page.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Mentone, CA
| Service | Typical range in Mentone |
|---|---|
| Service call and diagnosis | $85 – $145 |
| Hinge or roller replacement | $180 – $450 |
| Gate sagging or post settlement repair | $350 – $900 |
| Chain-link or tube-steel gate repair | $250 – $700 |
| Control board replacement | $450 – $1,200 |
| Operator or motor replacement | $750 – $2,500 |
| Photo eye or safety edge replacement | $200 – $500 |
| Driveway gate and hardware (no operator) | $2,500 – $6,500 |
| Complete automatic gate system | $6,500 – $13,000 |
| Operator and access controls only (on existing gate) | $1,800 – $4,000 |
Prices in Mentone push toward the upper end when a gate is wide, heavy, mounted on a slope, or exposed to full wind off the pass. Every job is quoted upfront, in writing, and the price you approve is the price you pay.
Neighborhoods We Serve in Mentone
We cover all of Mentone’s 92359 ZIP, from the flats near Mentone Boulevard up to the hillside parcels and equestrian lots along the base of the San Bernardino Mountains. Response time for repair calls is typically same-day or next-day, depending on parts and how far up the grade the property sits.
- Mentone Beach and the flats near the Santa Ana River
- Crafton Hills foothill parcels
- Mill Creek corridor acreage
- Equestrian lots east of Mentone Boulevard
- Hillside lots along Highway 38
Service Area – Cities Near Mentone
Riverside Gate Company serves Mentone and the surrounding foothill and valley communities. If your property is just over the line, you’re still in our service area. We regularly work in Redlands, CA, Yucaipa, CA, Highland, CA, and Calimesa, CA.
Serving Mentone, CA — Our Local Coverage Area
We’re based in the Mentone area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Mentone
Most Mentone repair calls are handled same-day or next-day. If it’s a gate stuck open or a security risk on an occupied property, tell us when you call and we’ll prioritize the dispatch. Parts for common brands are already on the truck for most of the area.
Most residential driveway gate installations on private property don’t require a permit, but automatic gates near a road edge or with vehicle loops can trigger a county review in San Bernardino County. Call (855) 942-4867 and we’ll tell you what applies to your specific lot before you commit to anything.
For repair work, we can often give a firm price over the phone once you describe the gate, the operator brand, and what it’s doing. For installation, we need to see the grade, soil, and driveway length, so we schedule a free on-site measure and provide a written quote before any work begins.
For a free estimate on gate repair, electric gate repair, or a new gate installation in Mentone, call Riverside Gate Company at (855) 942-4867.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Mentone Customers Say
"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Shannon Fletcher"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Nabil Saleh"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Chris Mercer